![]() Always disconnect tubing from the site on your body before going through the load sequence. Note: You can reload an existing cartridge if more than 80 units remain. You will need to complete a cartridge load process, re-start your CGM session, and confirm that date and time on pump are correct.Your pump experienced a reset and all deliveries have been stopped. To resume insulin, from the Options menu, tap RESUME INSULIN and tap to confirm. Tap and check the cartridge, tubing, and infusion site for any sign of damage or blockage and correct the condition.Review more thorough Occlusion troubleshooting here.Your pump detected that insulin delivery is blocked and all deliveries have stopped. Review proper cartridge load technique here.Tap and change your cartridge immediately by tapping OPTIONS from the Home screen, then Load.This is most often caused by dropping the pump. The pump detected unintended movement of the pumping mechanism. (Verify under Options > History > Pump History > Alerts and Alarms) Please make sure to have the pump alarm number and your pump serial number available at the time you contact us. If the alarm you are experiencing persists, please Contact Us for troubleshooting. This table provides pump alarm descriptions and recommendations for responding. Once you clear the Alarm, you will need to manually resume insulin delivery. but I appreciate the "magic" that can happen here.Alarms display automatically to indicate a stopping of insulin delivery. Assuming I did a "shutdown" at the end of the day, and the RTC alarm turns the computer on a specific time, how does this password get entered? If, instead of shutdown I leave the computer in some other state, would the passworld still reside from previous Windows startup? I've indicated the password is to be provided at Windows startup. In order for the update to run, once the computer is up and running, a Pin Vault password must be entered. Ultimately this is designed to allow Quicken to perform a "Scheduled Update". If I want the computer to turn on at 4 pm every day of the week how would I specifiy values for Date and Time? Once set, does this take place automatically after I Shutdown, or must I leave the computer in some other state? Options are to Enable/Disable, Set Date (0-31) and Time (HH:MM:SS). MSI K8N Neo4 Platimum Board provides Wake UP event Setup under Power Management in Setup. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |